This hydraulic filter is crucial for maintaining the cleanliness of the hydraulic fluid in your excavator's system, protecting sensitive components like pumps and valves from abrasive wear. It is constructed with high-efficiency media to capture fine particles, offering superior protection over a degraded or bypassed filter that allows contaminants to circulate. Operators may observe sluggish hydraulic operation, erratic boom or bucket movements, or unusual noises from the hydraulic system when this filter is compromised.
Always verify with serial number before ordering.
Parts Trading Company · Mumbai, Est. 1956 · Same-day dispatch · Ships worldwide · GST invoice included
From the same category — may also be needed
Full shipping information on regional pages · Air freight 2–12 days · GST invoice for India
Never run an engine without a filter — even briefly causes abrasive damage. Pre-fill fuel filters with clean fuel before fitting to reduce prime time. Replace O-rings on filter housings every second service. Record change dates on filter housing.
Always consult the OEM service manual for model-specific torque values and procedures. WhatsApp our technical team if you need fitment guidance.
Initial symptoms of a clogged hydraulic filter include slower response times in hydraulic functions and a slight increase in system operating temperature. If ignored, the filter can bypass, allowing contaminants to damage critical components, leading to unpredictable hydraulic performance and potential system failure.
Ensure the hydraulic fluid level is checked after installation and topped off if necessary, as some fluid may be lost during filter replacement. Do not reuse the old O-ring or gasket when installing the new filter.
Inspect the hydraulic fluid reservoir for signs of contamination and check the hydraulic pump for any unusual noises or vibrations.